The UK's biggest automatic scooter forum.
Separate names with a comma.
how much?
oh...and current engine is drum..... id love to convert to disk, but that may be too hard.
Thanks for the reply guys... Once again minor, you are a champ... Ill have a better look round here, and if i have no luck ill take you up...
Doods... Just enquired at a scooter wrecker how much a bottom end would be.... I dont want cylinder, piston, carby exhaust, variator etc etc....
ahhh yes.... should have used my eyes.... lookin good... how did you know where to grind, and how much....
ahhh ok.... you got any piccies of you ported cases? id love to get a 2nd engine that i can build up. I cant find one though. its a pain...
nope... i have considered it though..... I wouldnt bother on this engine... bit im open to getting another one and porting it..... The lack...
hehe no worries... I had planned on going on one.... until my bearing failed. Ive almost got it all back together now. will be a lot of...
ive got a '04 vespa et2.... its got the stuff in my sig.... next im thinking ill get a different 70 kit.... the one i have is about...
thanks man...i might give them a try next time i need something.
hey man, How do you find getting stuff off scooter centre..... what is the delivery time to aus? etc..... is it much cheaper than getting...
yeppers...did that.... inner race was hot... if i licked my finger and put in on the inner race, it sizzled hehe. crank slid in easily....
thanks minor... i have tapped it while cold with my rubber mallet... ill try heating the cases again and tapping it again.....
Just a quick one with end float.... If im pushing laterally on the crank (in and out) to test end float... should i feel it move? I dont...
how old is the fuel?
have you done anything recently .... like pull the carby off? assuming there is no mechanical damage... it can only be a lack of air, fuel or...
Thanks minor.... Wolffy... dont thing id trust your dads mates advise.... To quote an aussie radio talk back show...."oils aint oils"...
Hey Guys, What do you think of the silkolene? Atm im using a castrol TTS full synthetic... but i think this is over kill....How does the...
ok... is i got some 25mm angle... and filed it down to a wedge shape (see pic).... i then put it in the vice and applied pressure and heat....
tada its off..... man what an abortion..... ill post a diagram of what i had to do.....
