The UK's biggest automatic scooter forum.
Separate names with a comma.
You need to slack the cable off because when it's adjusted up it takes some off the slave cylinder movement and doesn't return fully.
Knight!
It can only go back one way so that the cables attach to the quadrant.
You can fit a new barrel with the engine in the frame, remove the top right hand long barrel stud, this alouw's room to get the barrel off!
No, the handlebar isn't long enough, the std typhoon brake system is fine if you know how it work's. You need to slack right off the cable and...
Open it up, look where the carb/oil pump cables run, you'll need to slacken off carb/pump cables to make it easier then reassemble.
It won't fit without modifying it, It will hit the fan cowling.
You don't, just wright on the back of the new speedo the old mileage reading, also put the old reading in the hand book/service record.
Pull the barrel off and have a look!
Rear wheel size is different, the clutch has 3 shoes like brake shoe's that throw out when engine is revved, the pivots on the shoes are dry,...
Yes, good call on the clutch, strip it down ,clean and lube all the pivots. Could be rollers on there way out and or variator worn?
I'm going to use 2 ignition pick-ups, 180 deg's apart, 2 cdi's. The cdi's wiring is piggy backed, it's only the pick up wire that's different.
I thought about 2 into 1 pipes but surely there not going to be as good as 2 separate pipes?
A new battery will only be around £35, well worth the money. From new or anytime it need's charging with a low amperage charger, less than 1 amp!...
I assume it's a 2t Hexagon? If so when it's on it's centre stand, hold the rear wheel top n bottom and give it a twist, you should feel and see...
Yes the pinch bolt is at the bottom of the leg and is the last bolt to do up after the spindle is fitted and tight, there is a wheel spacer on the...
Some scooters have a sidestand switch if the stand stay's down, if it flick's up it does'nt. It's a rotary switch on it's pivot bolt, they can...
You'll have to look deeper, it now sound's electrical, plug? water in the cdi/coil, loose terminals? side stand switch if fitted?
Drop the brake caliper off , undo the pinch bolt in the r/h leg, remove spindle. Make sure all spacers go back and re-assemble when done.
It could be the silent block and or engine mount bushes worn out.
