The UK's biggest automatic scooter forum.
Separate names with a comma.
As long as the wheels are in line, headstock to main engine bolt is correct then I'd bend it/cut re-weld it back straight. The panels will cover...
Hi, your going to need a box full of jets and just try changing them until it's right, start big and work down. Plug check will work on an auto,...
Loose the gear -up gears!
The water pump need's to be fitted in the water pipe from rad (cooler water) and going into the bottom hose on engine.
The frame could be bent on the rear section, it would still handle well due to the headstock/engine bolt area being correct!
Just to clarify, it's not a "Ped" but a scooter, Peds are 50cc. That's not a bad effort at all, very tidy! :D. Get the carb sorted and it will be...
The std air box will work perfect.
Yes, that's where it live's.
Looking good! It's the std airbox that join's the hugger to that fixing screw. The fan will have power all the time, it's more than likely to be...
It would have to be Runner 13" rear and 12" early Runner 50cc front wheel! The NRG 50 rear wheel won't fit . I had a radiator in the front panel...
4 years already! :eek:.
The ideal engine temperature is around 70 degree's c!
You can use the 13" 2t Runner rear wheel on the Dragster hub, you could use the early 12" 50cc runner front wheel as it uses the same speedo drive...
I think that thermostat housing is found on the 125/180 2t runners, early aluminium skull-caps. Just replace it with a new plastic cap, not...
That's a indicator relay, I'm sure the Runner is more than a std 2 wire job, you may have the wrong relay!
Once you have a new silent block, then get a piece of steel tube that's a nice tight fit over it. Weld the steel tube in place then fit the silent...
Don't forget the silent block that sit's on the engine bolt, the silent block as you probably know is just a rubber bush in a steel sleeve that's...
It's the same as a typhoon 125, there's a few on ebay.
I think it may have been a blocked waffle valve or a bent giggly pin!
Find out what size thread it is, 4/5/6/mm then get a load of jets and start changing them until it work's right.
