The UK's biggest automatic scooter forum.
Separate names with a comma.
Are you using the right clutch? Rolling or non-rolling type? The non rolling hs a spacer tube in the center.
Try it , as said in other posts, you need to find what works for the scooter, unfortunately there's no "one size fits all" setting.
Std air filter, std pipe works fine. If you won't to keep the zx pipe then you need to find out what it needs to work, rollers/clutch etc. there's...
Probably use the spacer off the old shaft. I'll look if I have an old one.
You can't have it driving as soon as you rev it, check for heavier clutch springs in the clutch. Any 2 stroke will have to rev to get in it's...
There should be a spacer between the bearings!
It's the carb float bowl drain pipe.
Yes it can be done with the parts listed, the non rolling engine is fine !
Yes it can be replaced, the Haynes manual tell's you how to do it, the special tool is a 8mm socket on an extension, LEFT HAND THREAD on the...
Width/ diameter.
Carburation/ transmission mods.
When I premixed the typhoon I just removed the oil sender unit from the tank and taped the float in the middle and tucked it away safe !
I'm not 100% sure but it must be similer to the typhoon, if disconnected it won't run and if it's in the empty position out the tank it blows the...
There's probably 2 meters of wire and was done by machine, a new solenoid is about £15.
Buy a new one !
I've never posted in this section before but I fitted a manual choke to "Beryl" (pictured left) this evening, I managed to find a manual choke...
You don't stretch and pull it, you remove the front variator, rear clutch to clean out all the old bits of belt. Refit and torque the said parts...
You undo it while it's still clamped in the yoke !
Personally I'd run it a little on the rich side, especially when the warm weather comes !
If the engine is an SR then you'll need to replace engine bushes or a thin spacer on each side to centralize engine. The typhoon/ runner mount is...
