The UK's biggest automatic scooter forum.
Separate names with a comma.
I figured it out. There was no clip. There is an o-ring around the barrel just inside where the key goes in. You just need to firmly push from the...
Anyone know how to get the barrel out of the outer shroud on a runner? [ATTACH]
Thanks. I'll keep the oil pump advanced and see how it goes. I guess if it is too smokey then I'll know to back ti off a bit down the track. I...
Bought a NGF 172 kit to replace the damaged top end on my 180. Fitting instructions state to advance oil pump by 3mm and upjetting. Do I need to...
I've replaced the silent block, engine bushes and nylon swingarm bushes on my FXR180 with standard items. Torqued it up to spec and replaced the...
I finally worked out what was going on if anyone is interested. I had previously taken the gearbox apart to change the hub bearing, and during...
Thanks a lot for the offer mate. I might take you up on it yet. I've been looking at some exploded diagrams of the driven pulley and I think the...
Now you have me thinking - I did change the bearing in it a while back... possible I could have left the spacer out I guess. Can anyone else...
No others to try unfortunately only my two different style ones.
Yeah your right it does not have a spacer inside the pulley like the old one does, but again I was pretty sure it was like this. How could the...
Thanks for the reply mate. It's not anything to do with the driven pulley/clutch assembly I don't think, because it is the weld line on the back...
Finally getting around to putting my SP180 back together after a long rebuild so it has been a long time since I've had the clutch assembly on it...
Thanks. Based on your advice I have been having a look at the yss ones. They have a pro-x model which is quite cheap and then an e-series which...
After changing the 4 nylon bushes and o rings on swingarm and tightening to specified torque, and also changing 2 outer engine bushes and rear...
Hi guys, Just replaced the original usd forks on my 180 runner with vx type. The bike is standard and I sometimes ride 2 up with the...
I eventually got the centre sleeve off them off by hammering a screwdriver at the base of the centre sleeve. Driven pulley has a few scars but...
Thanks but I tried that. I tried soaking overnight with wd40 at top and bottom, tried heating a bit. Both are frozen solid. If I ever get them off...
Just changed the clutch springs on my 2 180 runners. Thought i'd give the driven pulleys a clean and grease while their apart. Only problem is I...
Thanks. Ended up getting them in eventually. What a hassle. Put the green ones in - hopefully it will be worth it.
Bought a set of Malossi springs for my SP180. Went to fit the green ones but they don't seem to fit very well at all and i'm just wondering if...
