The UK's biggest automatic scooter forum.
Separate names with a comma.
I assume you replaced the main earth strap. They are usually attached to the starter motor bolts. Did you check the voltage at the switch? If not...
You'll have to go over what you removed when you took it apart. Did you take the engine out?
As Steve says you'll need to work back from the headlamp. Basically the regulator sends power to the dip switch and it then goes to the headlamp....
I've had an early burgman for some time but I now find it's a bit bulky for me. Basically I'm looking for a 250/300 scooter that is physically...
As said there are plenty of 3.50 x 8 tubes available just make sure you don't get one for a wheelbarrow lol Only thing you need to check is the...
Just one final thought. Compare the wiring on both switches and see if the same wires go to the same pins on both connectors. These switches fit...
Perhaps someone on here could help if they are local to you?
I thought we had established that when the yellow(power) and the bl/white wire were checked for continuity at the r/hand switch it worked so if...
So you are getting power across from the right switch on the bl/white wire but not through the switch? "Yes I I get continuity to right dip switch...
They probably match the headlamp colours. Green/blue/white??
Ok now test the left switch for continuity. Not sure about the colours but you should have the pin that the bl/white goes in so that is the power...
Left??
So the switch appears to be working? In that case when plugged in to the loom and the dipswitch side unplugged you should get a continuity...
Sorry I added a bit to the last post.
What are you using to test all this? It's very strange as basically the brown, yellow and bl/white wires are connected when switched on so...
Yes but you also have to connect the yellow. Let's carry on section by section. Leaving the r/hand switch still connected AND switched to main...
Getting confused now lol If you have power to the switch then check the new switch white/plug connecter to see if you have power coming out at...
Then the engine to switch wiring is faulty. I believe the connector from the stator/generator is behind the right hand rear panel above the...
Going back to my question do you have to have the engine running for the headlight to work? The yellow wire going in to the right hand switch is...
ok the blue/white wire runs across to the dip switch on the left. Start checking that side. Same procedure again check the white switch socket...
