The UK's biggest automatic scooter forum.
Separate names with a comma.
As above , strip clean and rebuild the carb , and stay away from that cheap oil , stick to decent stuff like castrol ,motul , putoline etc...
check when cold 0.10 in 0.15 ex They tend to close up on the inlets and make starting a difficult procedure.
Yes the oil feed nipple needs to be blanked off , check the frame to engine is well earthed. If it runs on easystart then you have a fuel delivery...
Is it a stock motor? Wat is the current last service/check over ? If you had the head off to check the head gasket , why not slide the barrel off...
bit of a streetfighter fan ay ? Lovely bikes anyway.
Yes they will fit, wouldn't opt for the jack up kit however. Handle bad enough as they are .
Its on the thermostat housing , remove the seat bucket and to the top right of the engine (exhaust side) there is a round plastic housing with a...
Parmakit , absolutly shocking ports , horrible cast marks and the piston hit the head due the squish being way wrong even though they provide only...
Nah don't bother mate , could never afford a set anyway , was just admiring. Again , lovely car , keep it looking that way. Some new (cleaner)...
looking well so far mate , i quite like the stock steel wheels, purely because they are unique in a way , just don't see them anymore ,everything...
Absolutely love these , those rims are noiceeeeeee . would love a set of them for my old banger . Roof rack must go surely ? Nice motor mate .
Re: helllpppppppppp please gilera runner not starting sounds like a pick up coil issue to me.
25 psi is a tad low in my eyes , i ussually run 30 front and 33 rear on scoots
1.25
looks good , but please get rid of those horid front indicators , get some flush fit ones or something.
sound more like a low battery voltage situation to me , have you put a meter across the terminals?
New plug ? even if a spark is pressent sometimes a old spark plug will not give a sufficient spark under compression, i presume you checked the...
Have you pulled the rear drive apart and slid the belt right down the pulleys to give enough slack at the front pulley before tightening it ? have...
http://www.gileraspares.co.uk/spares/epc2.asp?ModelID=1426&pageID=01.08&uid=0 Advise to also check the condition of the rollers whilst your in...
£120 does sound ridiculous , suspension bearing??? most likely referring to the bush at either top or bottom of the shock mount. Get them from any...
