Search Results

Search Again
Page 7 of 10
  1. scubabiker
    Post

    yamaha aerox spluttering and popping

    This forum is pretty quiet these days seems people just use Facebook these days.
    Post by: scubabiker, Sep 27, 2019 in forum: The Workshop
  2. scubabiker
    Post

    Yamaha Aerox won’t start

    The worst is "I can feel the compression on the kick starter"....
    Post by: scubabiker, Sep 26, 2019 in forum: The Workshop
  3. scubabiker
    Post

    Incredibly tight variator nut

    Bigger impact gun? Or heat? It can't be tight if you turn it to liquid
    Post by: scubabiker, Sep 26, 2019 in forum: General Tuning
  4. scubabiker
    Post

    Scooter Identity as Parts needed

    Idle speed screw has no "factory setting" per se. Just screw it in til you feel it pull the revs up a bit.
    Post by: scubabiker, Sep 26, 2019 in forum: General Scooter Discussion
  5. scubabiker
    Post

    Yamaha Aerox won’t start

    How much is loads of compression?
    Post by: scubabiker, Sep 26, 2019 in forum: The Workshop
  6. scubabiker
    Post

    Yamaha Aerox won’t start

    Compression?
    Post by: scubabiker, Sep 25, 2019 in forum: The Workshop
  7. scubabiker
    Post

    Scooter Identity as Parts needed

    Go up a tad on the main jet and see how it feels
    Post by: scubabiker, Sep 25, 2019 in forum: General Scooter Discussion
  8. scubabiker
    Post

    Scooter Identity as Parts needed

    Yeah that open vac pipe will give you problems. Top tip, the choke jet in the float bowl tends to get blocked, when you do your service just blast...
    Post by: scubabiker, Sep 23, 2019 in forum: General Scooter Discussion
  9. scubabiker
    Post

    Yamaha Aerox 50cc 2008 electric start problem.

    The one way clutch isn't engaging properly. Not often you see that problem.
    Post by: scubabiker, Sep 23, 2019 in forum: The Workshop
  10. scubabiker
    Post

    Baotian Carb. Setting

    Rich is good. These motors run super lean from the factory.
    Post by: scubabiker, Sep 21, 2019 in forum: General Tuning
  11. scubabiker
    Post

    Xmax 125 2007 won't start

    Connection to the MAF?
    Post by: scubabiker, Sep 18, 2019 in forum: Bike Chat
  12. scubabiker
    Post

    Speedfight 4 blown piston and plug pictures

    Must have been the oil pump packed up then.
    Post by: scubabiker, Sep 18, 2019 in forum: The Workshop
  13. scubabiker
    Post

    Speedfight 4 blown piston and plug pictures

    What oil has it had in it?
    Post by: scubabiker, Sep 16, 2019 in forum: The Workshop
  14. scubabiker
    Post

    Yamaha Aerox 2007, suddenly overheat warning, after new coolant

    Yeah Air in the system I'm pretty sure too
    Post by: scubabiker, Sep 16, 2019 in forum: General Scooter Discussion
  15. scubabiker
    Post

    Speedfight 4 blown piston and plug pictures

    Come on Steve. 2 rings. Wake up Ran too hot/lean, cheap oil.
    Post by: scubabiker, Sep 16, 2019 in forum: The Workshop
  16. scubabiker
    Post

    Scooter De-restriction

    I don't think there is.
    Post by: scubabiker, Sep 15, 2019 in forum: The Workshop
  17. scubabiker
    Post

    Scooter De-restriction

    Yeah there isn't anything in the carb.
    Post by: scubabiker, Sep 14, 2019 in forum: The Workshop
  18. scubabiker
    Post

    Scooter De-restriction

    You can use a safety pin to pop out the wire from the plug and see if it's a restriction.
    Post by: scubabiker, Sep 14, 2019 in forum: The Workshop
  19. scubabiker
    Post

    the what have you done today thread

    [ATTACH] [ATTACH]
    Post by: scubabiker, Sep 13, 2019 in forum: General Chat
  20. scubabiker
    Post

    Yamaha Neos 50cc build

    Geared bike section...
    Post by: scubabiker, Sep 13, 2019 in forum: Scooter Projects
Showing results 121 to 140 of 200 Next >
Search Again
Page 7 of 10