The UK's biggest automatic scooter forum.
Separate names with a comma.
sounds like the choke is over richening it too much. The rubber they replaced may have been letting air into the equation making the mixture...
depends on situation and available time to react.. One thiing for sure is always try to slide as opposed to rolling as theres less chance of...
helped a few out over time. Lad on a CBX1000 in town had a flat tyre (recon some arse had let it down) I fetched pump from home and then...
I have a tin that was mixed at a local paint factors. It has the codes on it somewhere if they've not faded over time. I'll have a look in the...
I was 24 when we bought our first house...a traditional end terrace (small and needing work) We moved aftyer 3 years to a semi..again needing work...
Halfords ratchet ring spanners are real good quality, smooth and take the strain too. i've used the full set for many years now and only issue is...
before you swap the bearings firstly make sure the originals are seated OK and you could try putting the old disc back on to see if it lines up OK...
its down to how often it gets wet and heats up, where its stored if its damp..loads of varients. Basically the more oil, less moisture, more...
is that where they lay the carbon 'paste' as a film on water and then slowly lower the part into it...when its removed and dried it leaves the...
even chrome needs maintenance. I used to WD40 my chrome allspeeds on the 350LC after each ride, quick spary and a wide..lasted 10 years but bike...
bit of an update but not alot. EXUP needed work so is in bits...subsequently RGs been put on hold for a while. plus I needed a few bits that were...
welding is possible with an iron but not a strong long lasting solution. Bodge.... in 1st pic...put a longer bolt in that hole from the other...
without it being chromed you're only slowing the inevitable. Its a good idea to wash and coat with WD40 but it'll burn off as soon as the bike...
spire clips and 5mm raised head screws...both available on ebay
you'll need the radiator and header tank inc all mounting brackets, the associated hoses back to the engine, the temp sender wiring for the guage...
If the off-set is the same as the old disc then it can only be 2 things, either the wheel isnt tightened enough to pull the disc in alignment with...
wudh'se close enough for you? :D
on bay if anyones looking to buy. Will deal off auction for cash in hand thanks http://www.ebay.co.uk/itm/151090756408
made me smile at least :D
are you actually serious????
