The UK's biggest automatic scooter forum.
Separate names with a comma.
I have been there, dialling in small carbs on modified engines, at best they work in a limited RPM range, but fail to provide adequate engine...
you mean something is in there ? probably you mean a tamper proof screw ? I think a photo of the carb might help, as the mixture in the winter...
not the best of jobs, if it is the seal leaking, k-seal or rad weld plus might seal it. if the impeller isn't broken, it can be done without...
these four stroke pipes make little difference, in some cases, rob power over the stock exhaust. Do a search for scorpion, and you will see the...
sounds like it needs to warm up to run correctly, with the air fuel ratio, it is getting, which suggests when it is cold, it is wrong. First check...
probably just an error, I personally know Dave(Euro,) from Suttons, just down the road from me. He comes up to a Sunday Scooter club meet in...
even in the 1970s, there was a few peds that could hit 50mph, a couple of the Fantics, Garelli Rekord and Tiger Cross, and the fastest and rarest...
there will be a screw on the pump, just slacken, when you can see oil flowing, and no air/air bubbles, tighten.
is the plug actually getting wet with fuel, after all the cranking, and failed starting ??
send me an e-mail addy, as I have a PDF file on the charging system showing the stator wiring out-put destinations, which is just as well as I am...
sent.
as they are a universal fit, you will be lucky, if you PM your e-mail, I have an instruction manual as a PDF. Very basic, but does giving wiring...
I have one on the shelves, for a speedfight 100, will cost you £5 because of postage, and will ruin my chances a bit of selling the variator. If...
an embarrassed 52.
it could be done, as there is a lip on the crank, after the splines. I took it that you were talking of running, none of the pulley at all.
on top of the piston, is an arrow, this needs to point to the exhaust port. The piston looks round, but is egg shaped to accommodate non-linear...
do you mean this bush, in the bottom half loop of the belt, in this photo ?? http://www.pedparts.co.uk/product/406/polini-speed-control-kit--piaggio
replaced with brand new, or one lying around ? and why did you change it? sure the oil pump is working? was it over heating? did you fit arrow to...
deffo go with the clutch springs, it might then prove a case that the roller weight is a little out, but get those stiffer springs in first, the...
the electric starter motor, drives a bendix, which engages on the teeth of the outer pulley/drive plate, if you don't have the variator in place,...
