The UK's biggest automatic scooter forum.
Separate names with a comma.
Have you tried refitting the transmission case? From experience parts like these that sit between the casings don't always properly line up/fit...
Welcome to the forum! I remember my 80's Suzuki GS125 and commuting the streets of London - lots of fun! As they say, the old ones are the...
Hi Corin, Welcome to the forum. Headlight - I had a quick look at an FZ50 wiring diagram and it only shows a single 'headlight' bulb. Are both...
Looks like the stud has snapped :( You're going to have to remove the remaining part of it with an extractor and fit a new stud. If the exhaust...
Hi, Do you know if your scooter has an automatic choke? (electric) I would remove the carb, clean it out and give it a good check. Thx Mark
Ha, it's not a laughing matter...:D Following my earlier feedback I decided to up my front fork rebuilding performance...:oops: I'm pleased to...
Well, in between going to work, being ill, not having a fully equipped workshop and just giving them some attention at weekends... Yes. :rolleyes:...
ok, got a bit of an issue with other fork - the allan bolt won't undo, fully...:mad: I broken the thread, the bolt undid about a quarter of a...
I had a go at the variator nut last weekend but still no luck.. Going to sort out my fork seals first, then come back to this - probably doing...
Thanks for the advice which was spot on upto using the upper part as a slide hammer. This fork has a different construction and the upper part...
I got the fork off. Removed the top access panel and could just see the inner edge of the top of the fork through gaps in the lower panel. Looks...
Doesn't have a sump - just a large drain plug with strainer - see post 7. What is the correct way of checking the cam chain? It's a 4 stroke....
[ATTACH] Part 18 - plug, inner tube Part 45 - ring, snap Part 17 - circlip Part 15 - bolt, cap Part 16 - ring, piston So is part 45 (snap ring)...
I've removed the drive belt off the variator and it still makes the noise...
I'm coming back to this now... Would the next step be to strip the engine and inspect small/big end bearings?
here you go... [ATTACH] [ATTACH] [ATTACH] On the right fork, I have undone the bolts and prised a screwdriver in the clamp gap for some...
Ok, does that mean some top caps overlap the retaining frame to hold the fork in? The guides I've seen are a mix, some remove the top caps &...
Thx for your reply. I've already tried giving them gentle persuasion. I'll try to dribble some lubricating oil at the top to seep down the...
Thx for your reply. Yes I mean forks :oops: I've tried that - loosened the 2 bolts on the frame, removed from the wheel, prised the gap with a...
Hi, My Yamaha Majesty 180 front suspension struts are leaking oil and it looks like time for a rebuild. I have removed the front mudguard and...
