The UK's biggest automatic scooter forum.
Separate names with a comma.
Heat gun may not help, your're expanding metal in the immediate area, this is surrounded by cooler, non expanded metal, it may actually expand in...
Hi guys, i've pulled the transmission apart a few times now, still not sure if there is meant to be a spacer on the driven pulley shaft between...
Ok, thanks for the feedback. Looks like I was being dumb, it does extend as it heats up, I think the spring just gives it a helping hand. I...
Hi guys. Had to change my carb, the idle air screw was seized solid and the bike was idling badly. Ive never known a bike that was so prone to...
Thanks, have tried that, they were actually ok, clutch grabs too soon so im thinking cvt spring. mine measures 112mm, the only specs I could find...
reduction unit cover will have to come off. search for scribd typhoon 125 manual. you might get away with leaving the exhaust on but rear wheel...
Come to the conclusion that it's the clutch/rear pulley assembly that's at fault, I suspect a weak contrast spring and possibly weak clutch...
The question is, is it the starter motor that's seized (relatively easy) or the engine (not so easy and probably expensive). If the latter then an...
You need a blast cleaner to clean effectively, any problem fouling will be inside the threaded metal shell where a brush won't reach. As long as...
Thinking about it logically, it's unlikely both engines would cause the same vibration. If you didn't have this problem before taking the first...
Hi guys. Typhoon 4t is now getting some use. Had a problem with the bendix having a bit missing and not disengaging, replaced and sorted. BUT...
Ok, sounds like a plan Cheers H
Yes, I meant the driven pulley with clutch. The problem with the parts diagram is that it doesn't show the transmission cover, the big nut...
The bearing adjuster shouldn't be much more than finger tight, a few careful, light taps with a drift (hammer and screwdriver) is all that's...
Hi all. Almost finished the rebuild, just a couple of minor things that are new to me (used to bikes rather than scooters). I've come to...
Ok, thanks, engine now back in posting my next 'problem' now. Cheers H
Thanks for the reply MARSH. I'm not sure what spec the cam is, it's the first one of these engines I've ever looked at. Attached a couple of pics....
Ok, think I've identified the casing mark, slightly to the right of where I had marked in the pic but I now have another problem. The manual at...
Finally got it out! Cut a slot lengthwise across the engine casing using a thin cutting disk on an angle grinder, did this to release any pressure...
Hi guys, putting the engine back together after a bit of crankcase welding, stud removal/replacement etc, now need to time the valves to the TDC...
