The UK's biggest automatic scooter forum.
Separate names with a comma.
if the bowl is not air tight the engine will suck air in anywhere it can get it. Since the level is below the edge of the bowl - especially on the...
this is why you need to get the bowl tight with a new gasket. Call dell orto uk. They are great.
Reading all this again I think that Merlin is right and your auto choke is knacked and 'on' permanently. That is why your scoot starts fine but is...
Took gf's scoot for an 8 am ride this morning to get a new rear bulb. I dunno whether it was some crap in the carb, the depression pump (replaced...
Agree with Steve 100 percent - except to say that for top speed I'd say 50 tops with a decent variator. Piaggio parts are all bigger and better...
Cylinder looks great. Piston could do with a bit more - attack it at 90° to the visible scratches. For the clips - yes. Still easier than those...
You can either order one from http://www.dellorto.co.uk/ (contact details at the bottom of the page - brilliant service) or you could try glueing...
sounds like the carb need a clean with compressed air. Also, if it only runs properly with the needle in it's richest position (bottom groove) I...
Yes indeed. Bust reeds muck up the mixture and make it hard to start the engine. if you're fitting an open filter you need to upjet by about 50...
nah. Sounds fine. Do a google search on cylider honing.
The streetrace is a cast iron kit. it will not rev high enough for the C 20.
70 is indeed a good deal - but you would need a strong crank, at least a stage 6 sport pro cylinder and a 21 mm carb. You'd need a box of jets...
I think we're going to be seeing more four stroke crap rather than 125 two strokes....
http://49ccscoot.proboards.com/thread/1727/spark-plug-reading-tuning-info have a read here -
upjet & see!
Hi probably not. But a Yasuni R with a bigger main jet and lighter rollers would.
Hi. Possibly too poor. Might need to upjet 2 to 5 points.
check your plug. More air needs more fuel. Might need to upjet a bit.
If the bowl is leaking, remove it. remove the seal, put it upside down on a sheet of glass with a sheet of new 400 grade emery paper. put a drop...
