The UK's biggest automatic scooter forum.
Separate names with a comma.
Sadly Scooter-center does not sell a 55 stroke and 105 conrod version, so i will have to go with 110 conrod. So with the 110 conrod i will need to...
Hey, I'm going to get the BGM Evolution 2 stroker crank for my 172cc MBK Booster. The crank comes with the needed 5mm spacer, but the question is,...
On most scooters you need to remove the whole clutch assembly in order to remove the drive belt. If you change the belt, i would suggest...
Hope it's of any help, but heres a list of bikes that use the same number light. Atlantis 100, Atlantis 4T 100 2004 2A ED, Atlantis 4t 100cc...
The TNT carbs are like lottery tickets - if you win, Congratulations, it runs well. If not, well... Better luck next time! Use the 17.5 carb and...
Bogging sounds just like you say it, bike starts to die, doing loud BOOOOooooo... If thats the case, you need a bigger main jet. If the bike...
I, honestly, have never torqued the variator nut to spec's, i just get it fingertight then use the impact wrench to tighten it up, never had a...
First up, the basic derestriction. The piaggio Hyper2 is restricted by intake, exhaust and variator. First and easiest task will be variator, by...
The airmix - or idle mixture screw, barely - if at all affects the mixture at more than quarter throttle. Mostly it affects the mixture at idle,...
Lighter rollers are used if you use an aftermarket exhaust or tuning cylinder. As they work at higher RPM's, you will need lighter rollers to keep...
Lighter rollers DO NOT affect top speed, and if they do, it's only half a mph here or there. Lighter rollers keep the engine at higher rev's, as...
If the carb slide was 1cm open, then either the throttle is on(cable not long enough) or the idle rev screw is fully screwed in. The engine would...
Typhoons have the bearings inside the gearbox. To get to the bearings, you need to remove the variator cover, clutch and rear pulley's, rear wheel...
It is actually possible that the carb is flawed, and you wont be able to get it running well.