The UK's biggest automatic scooter forum.
Separate names with a comma.
Zip rollers are 15.5 19x
2000 rpm clutch springs are in it at the moment? They don't get much better than that?
Or you could try re running the cabal so it gives you some slack?
You need a new cabal it's to short so when it's in the carb it's so tight the throttle is stuck open and you need another few cm cabal to allow...
[ATTACH][ATTACH] took some pictures from the back
Piston rings are fine and the compression is fine too. And I put 2k clutch springs in it so they are quite new?
Someone please help its starting to do my head in now. When it's cold and I pull back to full throttle its pulls away fine and fast but after a 10...
That pipe that comes off the original exhuast make sure you plug it up with a screw or it will suck in air making the ped go slow
Mine is a 2001 piaggio zip ac with a zx exhaust malossi air filter malossi rollers and belt it's been polished and a stage 6 clutch and custom...
It might push 65 70 but 70 is just acceleration the gear up will add top end but remember its a ped your end up spending ££££££££ to get an extra...
Check the exhuast is done up tight!!! And check your carbs clean I bet it's got dirt in the jet.. Easy fix and also if it is a dirty carb check...
Unless you gear them the gearing runs out at 58mph but remember ped speedos suck so it will probs read 70 lol
Sounds like a air leak make sure everything is connected properly and everything is done up go buy some clips they are cheap and if it's not that...
Stage 6 clutch and as for the gear up kit it's a good question I think it would slow down the acceleration but have a higher top end but It would...
