The UK's biggest automatic scooter forum.
Separate names with a comma.
what jointing compound should i use for the two halves? I used hylomar blue last time. Used it on my 180 before and it was sound. Who's runner...
yeah i did raise the needle mate i'll be honest it didn't make a noticeable difference. I give up i'm gonna be sticking it in the trade it in a...
all screws done up tight and even went to the extreme on putting a hose clamp on the rubber arggh :rant: cheers tho mate
Right! Today i reset the carb settings all standard jetting etc and cupped my hand over the inlet and it was ok revved up fine as long as my hand...
i was under the impression that if you de restrict a 50 then it needs upjetting? Bore is fine. Can still see the honing marks on the barrel. Put a...
sorry i don't think i explained myself properly. The bike seems to run okay and start ok. Just when you open up the throttle up fully it starts to...
if the noise was coming from the case could even be something simple like the main seals blowing out, if the crank still turns smoothly that is,...
Hi there (again) Is anyone able to suggest what the symptoms would be, i'm not too sure how to check but i'm thinking my nrg issues (previous...
yeah i have quite a few special tools for splitting casings, presses pullers, holders etc, they were fitted correctly, i put a larger jet in...
heres a link with a vid. the sound might help someone diagnose? when i rev, the i have to let off quickly or it will just cut straight out, i have...
I'm having the exact same problem, bike is std tho i put a new crank in, and mines an nrg with a polini variator, i don't think it is the rollers...
hi there, I recently bought a nrg 50, needed a new crank due to splines being worn out and half pulley just spinning up on the crank. i put a new...
