The UK's biggest automatic scooter forum.
Separate names with a comma.
As Header says we have the newest version of the TDR "Tyga" exhaust system listed on Ebay as well as our website http://www.tdrscooters.com. Full...
The problem is your 02 engine uses the older (long wire) stator system and the new 09 engine uses the more modern (short wire) system. Old has the...
On one Moto Roma we found a restrictor in the throttle slide to stop the slide opening fully look in there.
Then your going to have to fit a bigger carb anyway if you go down the 172 and pipe route. :banghead: Why not just do it now instead of fucking...
Our TDR Race Exhaust fits the air cooled engines http://tdrscooters.com/Services.php scroll down to the bottom of the page for details.
Koso or OKO 24mm flat slide carb would be good :)
If you are running 20 x17 rollers and you replace them with new 19 x 17 rollers you`ll have to remove 1mm of shims to correct the spacing, but now...
Amazing how shifting washers and 0.5mm shims can make a difference to the set-up eh? :grin:
No it won`t, it seems some where along the line some one has lost a washer and replaced it. The two washers should be identical size but different...
There dos`nt seem to be anything missing but the variator spacing is wrong. As long as the thick washer sits over the crank and on the end of the...
Time to get the verniers out then. Measure your rollers, make sure they are 19 x 17. Make sure you have the two washers on the variator the...
We measured the belt off an old Hexagon (10" wheels) and it was the same length as the Polini 180 belt (we keep it as a stand by for sprinting as...
125 belt is 832mm by 18.5 wide. 180 belt is 836mm by 18.5 wide. Save you buying the wrong belt again why not just buy a Polini 180 belt part...
I`d suggest you measure them, I may be wrong but you could be useing 20 x 17 rollers in what is definately a 125 variator and it does make a...