The UK's biggest automatic scooter forum.
Separate names with a comma.
if your fitting the sport pro mk 11 then ditch the pro rep pipe fit a yasuni c16 then fukin hold on tight !!! cheers Andy.
hi sutty, its saved you a job as the first thing i do is remove the ring its commonly known as the rattle ring because it always eventually loses...
hi buddy, the original piaggio clutch and bell is fine just add some white or red springs so save your money, the contra spring should stay stock...
hi Dave, i would fit 5 - 5.5 gram rollers, take out restriction ring in the variator, remove the restrictor snorkel in the airbox, and then re jet...
This is an easy fix, The leader plug's 5 pins are the 3 phase, one pin is the oil sender, the last pin is the pickup, you will need a 3 phase...
its your £180 to burn, if i bought a mount and then needed to fabricate / mod it to fit then i would save the outlay and just fabricate one in the...
that gorilla arm will only fit 2t motors
go for it gary, the castle washer and washer are only there to put lateral force into the variator half, the castle washer is castellated so the...
i always use a bolt or a self tapper smeared in jb weld, never fails cheers Andy.
Hi Sutty, The pipe goes through a heat sink plate that is screwed to the carb, it acts as a heater to aid the choke, it is not really necessary...
hey cowboy, where you from ?
i have spent many thousands of £'s over the years with Pedparts, Andy and Richard are always polite and courteous, having purchased hundreds of...
Hi buddy yes been there and done that on a s6rt 69cc zip sp , it was lethal and is the reason i have titanium knees hips and elbow, nearly killed...
if you actually look at a zip125 mount you will see its built identicle to a gt/gts mount only shorter trust me, i have many years engineering...
oopsclunkthud had an engine mount made, however i do know a piaggio zip 125 engine mount will allow you to fit it , you will need to cut a 2"...
