shaft move in and out

Discussion in 'General Scooter Discussion' started by Lucciman, May 1, 2022.

  1. Lucciman

    Lucciman New Member

    Messages:
    4
    10F9FB90-064D-4961-83FF-17328657861C.gif D894F247-3D0D-41EA-806A-C07BF13A6A39.gif
    i would like to know what could be a problem because my shaft is moving in and out but just little and my driven pulley is touching the engine … i dont know but the bearing from the back of the pulley the idle bearing is loosen like move up and down !
     

    Attached Files:

    Last edited: May 1, 2022
    Lucciman, May 1, 2022
    #1
  2. MARSH

    MARSH Whooooo!

    Messages:
    3,212
    Rides:
    Piaggio Typhoon
    What scooter ?
     
    MARSH, May 1, 2022
    #2
  3. Lucciman

    Lucciman New Member

    Messages:
    4
    liberty piaggio 125cc
     
    Lucciman, May 1, 2022
    #3
  4. MARSH

    MARSH Whooooo!

    Messages:
    3,212
    Rides:
    Piaggio Typhoon
    It must have a nut on outer cover for clutch?
     
    MARSH, May 1, 2022
    #4
  5. Lucciman

    Lucciman New Member

    Messages:
    4
    it does but itwhen i tight to much pulls the bearing to inside !
     
    Lucciman, May 1, 2022
    #5
  6. MARSH

    MARSH Whooooo!

    Messages:
    3,212
    Rides:
    Piaggio Typhoon
    Have you got the spacer between clutch bell and outer cover ?
     
    MARSH, May 2, 2022
    #6
  7. Lucciman

    Lucciman New Member

    Messages:
    4
    yes i got all in place
     
    Lucciman, May 2, 2022
    #7

Share This Page