Piaggio Zip SLOW!

Discussion in 'The Workshop' started by Wunny, Oct 7, 2011.

  1. Wunny

    Wunny Member

    Messages:
    59
    Rides:
    Piaggio Zip 50 2T
    My Piaggio Zip is soo slow! My half revs are better then my full revs, when I full rev it just bogs out. It's annoying me and it seems to get slower and slower everyday. It use to go about 55-60mph now it only goes 45 tops. :banghead:
    My setup:
    17.5mm Delorto Carb,
    115 JET
    70cc Sport Polini Kit
    Leo Vince TT de-restricted one way
    PM Tuning Open Air filter
    Malossi 5.5 gram rollers

    Any ideas? :cray:
    Thanks,
    Nathan
     
  2. eG x LoGiKzZ

    eG x LoGiKzZ New Member

    Messages:
    12
    if it bogs at full revs i that means the jet is too big and letting in too much petrol, try a slightly smaller one and see if that changes anything.
     
  3. Wunny

    Wunny Member

    Messages:
    59
    Rides:
    Piaggio Zip 50 2T
    I took it to a garage and they set it up for me.
     
  4. Wunny

    Wunny Member

    Messages:
    59
    Rides:
    Piaggio Zip 50 2T
    ???????????????????????????????????????
    HELLO??!?!?!
    ANYBODY OUT DERE?!?!!?
     
  5. Jonnymarrw00t

    Jonnymarrw00t Moderator Staff Member

    Messages:
    3,243
    Rides:
    Piaggio Zip 05 plate
    No. The jet is not too big. It's too small. My zip, Polini Sport,Leo TT,Polini Filter,17.5ml carb other tranny bits, Running a 118 jet, 6.1 gram rollers,Medium clutch springs. Pulled 58mph and 9.18 bhp. Before anyone says wrong. This was proven and setup on a dyno :').
     
  6. Jonnymarrw00t

    Jonnymarrw00t Moderator Staff Member

    Messages:
    3,243
    Rides:
    Piaggio Zip 05 plate
    No. The jet is not too big. It's too small. My zip, Polini Sport,Leo TT,Polini Filter,17.5ml carb other tranny bits, Running a 118 jet, 6.1 gram rollers,Medium clutch springs. Pulled 58mph and 9.18 bhp. Before anyone says wrong. This was proven and setup on a dyno :').
     

Share This Page