Hi new here, speedfight 2 a/c 08, need help tuning??:)

Discussion in 'Introduce Yourself...' started by jessegriffiths12, Aug 25, 2013.

  1. jessegriffiths12

    jessegriffiths12 Member

    Messages:
    64
  2. Mark Emerson Trentham

    Mark Emerson Trentham Well Known Member. Staff Member

    Messages:
    8,575
    Rides:
    NSC110/ ET2.
    Welcome,
    an you might wanna try the tuning section. ;) .
     
  3. jessegriffiths12

    jessegriffiths12 Member

    Messages:
    64
  4. Rebel without a clue

    Rebel without a clue Active Member

    Messages:
    164
    Rides:
    2000 Speedfight 50
    Welcome fellow Speedfighter.
    How fast can you go on yours?
     
  5. jessegriffiths12

    jessegriffiths12 Member

    Messages:
    64
    Hello:) well it's got 50 mph on clock and it goes a little further then bounces so just over 50:) you??
     
  6. Rebel without a clue

    Rebel without a clue Active Member

    Messages:
    164
    Rides:
    2000 Speedfight 50
    Got mine to 55 (on the speedo) on the flat and almost up to 60 on a slight downhill slope.
    Still experimenting with different setups at the moment.
    Currently got a 76 jet, Leo Vincent exhaust, 7.5 gram rollers and a motoforce variator.
    No idea what I'm doing but it goes twice as fast from when I bought it.
    Seems to run loads better without an air filter although that's not a good idea.
     
    Mark Emerson Trentham likes this.
  7. jessegriffiths12

    jessegriffiths12 Member

    Messages:
    64
    I've taken my performance pipe off and replaced With the one I had with bike, it runs a lot better slower from 0-10 but much much faster from 20-45 but it does about 48 flat out which is fine by me, any tips to get it faster from 0-10
     
  8. jessegriffiths12

    jessegriffiths12 Member

    Messages:
    64
    & I'm not sure if its the standard pipe it's ginda the same but with a carbon fibre piece on the end
     
  9. Rebel without a clue

    Rebel without a clue Active Member

    Messages:
    164
    Rides:
    2000 Speedfight 50
    Lighter rollers?
    Mine does a similar thing. Was. Slightly better with lighter rollers.
    I'm gonna go even lighter and see what happens.
     
  10. jessegriffiths12

    jessegriffiths12 Member

    Messages:
    64
    Ok thanks I think I have 6 in now, also when I pull off there is a rattling under seat and footboard any idea?
     
  11. Rebel without a clue

    Rebel without a clue Active Member

    Messages:
    164
    Rides:
    2000 Speedfight 50
    Dunno about the rattling. Check for missing bolts and loose trim.
    My bike came with a box full of 'spare' bolts that the youth had left over when he'd been working on the bike.
    I seem to spend a lot of my time finding homes for these bolts and the rattles are slowly disappearing!
     
  12. Mark Emerson Trentham

    Mark Emerson Trentham Well Known Member. Staff Member

    Messages:
    8,575
    Rides:
    NSC110/ ET2.
    Check to see if you've a cushioning rubber on the back of your
    Centrestand!. ;) .
     
    Rebel without a clue likes this.
  13. Rebel without a clue

    Rebel without a clue Active Member

    Messages:
    164
    Rides:
    2000 Speedfight 50
    Yeah, I need one of those too.
     
  14. Mark Emerson Trentham

    Mark Emerson Trentham Well Known Member. Staff Member

    Messages:
    8,575
    Rides:
    NSC110/ ET2.
    You would'nt believe the racket that can cause if
    You int got that little rubber . :) .
     
    Rebel without a clue likes this.
  15. Rebel without a clue

    Rebel without a clue Active Member

    Messages:
    164
    Rides:
    2000 Speedfight 50
  16. jessegriffiths12

    jessegriffiths12 Member

    Messages:
    64
    Hi all. I went out on bike yesterday and the rattle has gone! :D I don't know what it was but its gone
     
  17. Rebel without a clue

    Rebel without a clue Active Member

    Messages:
    164
    Rides:
    2000 Speedfight 50
    Check round your bike.
    Whatever is missing will be the cause of the rattle!
     
  18. jessegriffiths12

    jessegriffiths12 Member

    Messages:
    64
  19. Mark Emerson Trentham

    Mark Emerson Trentham Well Known Member. Staff Member

    Messages:
    8,575
    Rides:
    NSC110/ ET2.
    Sometimes you need to think outside the box,
    What you think may be causing issues,could possibly
    be something else entirely!. :) .
     
  20. Rebel without a clue

    Rebel without a clue Active Member

    Messages:
    164
    Rides:
    2000 Speedfight 50
    Very true Mark. What I thought was a carb issue turned out to be worn rollers!
     
    Mark Emerson Trentham likes this.

Share This Page