Flywheel puller thread size for piaggio 50 and 150 2t ????

Discussion in 'The Workshop' started by сука ьлять, Jun 7, 2017.

  1. сука ьлять

    сука ьлять New Member

    Messages:
    16
    So, I need to get a flywheel puller to remove the stators from both engines, but I'm confused because on a couple of forums I found different answers.
    One is a 50cc watercooled from a derbi gp1 (same as the runner as far as I know) and the other is a 2 stroke air cooled 150 with a 10inch wheel.

    I measured both stators at around 26-27mm, with a generic tape measure.

    this one is m26 and it says it's for 50 2t stator
    http://www.pedparts.co.uk/product/616/piaggio-flywheel-puller

    and this one is m28 and is compatible with the 125 2t stator
    https://www.beedspeed.com/tool-flywheel-puller-vespa-aprilia-gilera-piaggio-italjet-p-227.html

    Are these the correct thread sizes, does anyone know for sure?
     

Share This Page