clutch

Discussion in 'The Workshop' started by haz_666, May 13, 2007.

  1. haz_666

    haz_666 Member

    Messages:
    106
    whats the best way to hold my cluch bell thingy wen i take the nut off as i dnt have anything big enough to go around it?? I dnt wana buy anything if i can as ive gt plenty of tools but im jst findin it hard to think of a way...

    Cheers
     
    haz_666, May 13, 2007
    #1
  2. tweak

    tweak Member

    Messages:
    652
    Clutch Bell? Hold the rear brake on... if you can't hold the wheel whilst undoing the nut
     
    tweak, May 13, 2007
    #2
  3. JakeSP

    JakeSP New Member

    Messages:
    391
    x2, If its real tight get someone to sit on it (both wheels on ground) while they hold the brake and you undo the nut.
     
    JakeSP, May 13, 2007
    #3
  4. nrgandy

    nrgandy New Member

    Messages:
    2,180
    i use a ruber belt tool thing
    before that i either used the brake or jamed a old hammer in wheel and engine and i sometimes use a impact wrench
     
    nrgandy, May 14, 2007
    #4
  5. wobbly_trials

    wobbly_trials Active Member

    Messages:
    6,676
    Rides:
    RD350, SR125, ICE125
    a well placed screwdriver can somtimes work.
     
    wobbly_trials, May 14, 2007
    #5
  6. MiNoR cOnFuSiOn

    MiNoR cOnFuSiOn Administrator Staff Member

    Messages:
    14,276
    Rides:
    et2 monster
    get an old seatbelt out of a scrapyard and a set of mole grips.. pintch the belt round the bell and hold the grips, as you turn it will get tighter ;)
     
    MiNoR cOnFuSiOn, May 14, 2007
    #6

Share This Page