The UK's biggest automatic scooter forum.
Separate names with a comma.
Hiya, I took it to a garage in the end and it turned out to be a loose earth wire, I would check your wiring for corrosion, breaks in wires and...
I blew the engine on my speedfight so I am going to rebuild it later today. The garage I took it to said i only need a piston kit and small end...
Sorry for the very very late reply. I found a loose earth cable under then engine that attaches to one of the starter motor bolts, took it off and...
changed the carb and vacuum pump today aswell as installing a manual choke, even worse :/
yes it was,nice and snug as was all the other pipe connections regarding fuel
i drove with out the petrol cap on and it ran crap, i then put fresh hoses on and still ran crap. i then sucked on the vaccum pipe and took of the...
even though when you rev the bollocks off of it ,it runs sweet for a while?
the spark plug is a coffee brown atm, just checked again. i have noticed though that when you raise the rear wheel and full throttle it for about...
ok im really stuck, i have tried jets 72 to 80 and with each jet i have had the needle on lean, middle and rich all with the same bloody result. i...
i wasn't able to have a look tonight as my tools are at work but if it help, the carb was "spitting" fuel mist into the airbox/filter causing it...
ok,my mate had a manual choke that i could borrow so i put that in aswell as down jetting from 80 to 78 and out the throttle needle on the middle...
I like the sound of the bike without the air filter, sounds more roarty
haha fairenough il order one :) regarding the air filter, should i get an open filter or downjet and keep with stock?
i took out the auto choke while still plugged in and started the bike, the choke body got warm and the needle looking thing extended. i have just...
what about air filter?
OK so I took off the air filter and had the needle on the richest setting, I then took it down the road and it had improved slightly, I pulled...
I cleaned the carb this morning and put the needle on the middle setting (works best in this setting) but again once warmed up, doesn't run properly
it just doesn't add up that i ran this setup for a good two weeks going through 4 tanks and now BOOM shit hits the fan and it wont work :confused:
its jut occurred to me, there isn't a fuel filter on it, would there be something blocking the main jet?
ok il try it and report back, thanks
