The UK's biggest automatic scooter forum.
Separate names with a comma.
Found an old image about the Dyno! http://sphotos-e.ak.fbcdn.net/hphotos-ak-snc6/265948_151933568215183_7217511_o.jpg
Like any other scooter transmission ... There are lots of beginner guides on the internet about that problem.
I do not have the right components? Well, you roughly have the same components as I do, so I don't know what you are talking about. A bigger carb...
Tried to rev too much, and it sounded like it hit a revlimiter? Well that's too bad, the BWS doesn't have any kind of rev limiting. It is able to...
Why not? Explain please
Haha, those aren't mine, I was holding the camera! :D Yes at the moment I'm in Hungary, but I'm moving to London in the summer of 2013.
The clicking sound when you press the starter button is totally normal. It is made by the starter relay. You don't have to worry about it.
Tried checking the vacuum hose between your carb and fuel pump? It might be a bad quality one. Also check your intake manifold, they commonly...
It may be possible because of your Jack-up because your carb gets tilted to the back a little bit more. You should also take a look at your fuel...
Well, I'm not going to lay out all the cards! ;) But basically, it's worth it, your ride could make 16 Bhp at rear wheel with ease, if set up...
Okay I'll tell my opinion about this subject, from my experience: The things you need: - Correct piston-cylinder clearance - Quality piston, not...
Of course. Take the block apart, push the crankshaft out of the bearings. It is important to leave the bearings inside the crank case. Clean the...
It should be around 110 if you are not using your powerjet system! Always start jetting from rich to lean and stop as soon as it gets worse after...
Welcome to my profile! I tune and repair scooters all the time. Contact me for Cylinder porting, crank case modding, etc.
What does it do exactly? Over a certain RPM it begins to stutter, like a car rev limiter but very fast?
Sure. A Hungarian guy made this for me, based off yasuni C30. I had a team2 before, works much better with this new one. More power at high rpm's,...
Hehe. Lifts it's front at 50km/h :eek: Yes I use stock gearing, although it could do well with a +21% primer, I just don't have the cash for all...
Here's a minarelli crank I made for a polini evo 50. Had to leave the cylinder stock, though crank case modification was allowed. Unfortunately,...
Thanks! :)
Current config: - Metrakit pro race 2 70cc slightly modded tunnels, original porting - Custom exhaust, based on Yasuni C30 but modified - Mikuni...
