The UK's biggest automatic scooter forum.
Separate names with a comma.
finally the bike started again........... took it out for a ride.............started bogging down.............then picked up speed finally...
HI, BIKE HAS BEEN STANDING FOR ABOUT 3/4 DAYS, IT STARTED RAINING AND BIKE GOT WET (COVER BLEW OFF) NOW, BIKE IS NOT STARTING AT ALL. IVE...
yes the pipe with the red line has to be cut and the other pipe which has a green line has to be cut aswel, which leads to a filter box, there is...
how do i block the plastic pipe that goes into the air filer. there are two pipes: 1 metal pipe from the exhaust to the air filer that i will...
shall i cut both pipes, leave about a inch and then crimp/weld the ends
two questions, i want to derestrict my exhaust, i no i have to cut along the red line but do i have to cut along the green? that pipe goes to a...
got it started, idle screw is 3 1/4 turns out, thanks. found what the problem was, the air intake clips were very loose and were letting in too...
i just changed the carb cos the old one was leaking, got a 17.5 replacement. now the bike will not start. also there is no fuel coming from the...
sorry there is another screw, the screw that im talking about i believe controls the pilot jet?
no they are both on there, i have turned the mix screw 2 turns from closed position and the idle screw is about three turns. i havnt taken any out.
no the only thing i did was clean out the carb, do u think it has something to do with the jets? i couldnt tell how fast it was going before cos...
still having same problems, gotta fix this before i start modding.......... it speeds up to half throttle and eventually top speed is 32mph with...
i have only derestricted the variator, i took it for a ride today and only got to 32mph, is that about rite??
i have the standard pipe at the moment, but thinking of getting a leovince zx. does the pipe make a difference in speed??
if i were to for the time being, until i save some funds: derestrict variator (remove 2 washers) derestrict exhaust malossi 5g rollers upjet...
i think i have a leak from there, i have changd the float and pin, gaskets. dont no what to do. the leak started after i filled the tank, also it...
i have cleaned my carb twice and changed the gaskets but its still leaking, its a little leak but its still there. one question is where does the...
the new clock is ok, but the speed sensor does not work, will a koso aftermarket speed sensor work with the original clocks???
do i need to get a 70cc cylinder kit or the 70cc piston kit, will any gear up kit do???
what size jets
