The UK's biggest automatic scooter forum.
Separate names with a comma.
having problems with my carb, it overflows, and has more leaks than a vegan casserole :) I want to move away from autochoke. and fit a cable choke...
I have 4 wires coming from the oil level sensor, with the 4 pin connector disconnected, all 4 from the sensor have continuity with each other, is...
my battery reads 19 volts across the terminals, I have smoke coming from the ignition block my cdi cuts out then it starts straight away again. my...
I see some people post here and elsewhere about squish, compression and gaskets. the advice is always to adjust the base gasket which would affect...
I see a few ads for suspension blocks that raise the rear shock, but I'm trying to assess the benefits, is it for allowing a softer suspension so...
just thought I would share the points system DVLA use for registering radically altered vehicles. Keep the original registration number Your...
Thought I would start a thread on my Liberty. I will try to get the pictures in the correct order. Bought it as a non runner and was headed for...
I decided to remove my rear hub the other day as I will be putting new bearings on the wheel shaft, drive shaft and replacing the carrier bearing...
had no spark on piaggio liberty 50 so decided to post this guide to what you should read from each wire with a multimeter. 1. Disconnect the CDi...
I have a set of Naraku morini piston rings and 10mm gudgeon pin. from Naraku set NK 101.80 they are going to rust if no one uses them. send me an...
we all like to have the best parts for our scooters, as we like them to be clean, but sometimes you have to wait until they arrive or you need...
I am going to be installing a 70cc kit on my piaggio in the summer. would anyone like to post their recommendation based on their own experience,...
just letting folks know, I got my moped stolen a few hours ago, the one on my avatar. reg BV51 LCA I restored it from a wreck and now I have no...
just restored an AP50 scooter and I'm back on 2 wheels again. Have had bigger machines in the past but I am completely loving the moped experience...
I'm looking for a high temperature exhaust paint with posssibly a rust proofing agent, to paint the downtube of the exhaust. has anyone any...
