The UK's biggest automatic scooter forum.
Separate names with a comma.
Will the cable disconnect from the head so I can replace the wired bit or is it sealed so I need to remove the wheel and entire unit?
hi, speedo stopped working on gilera dna50. Its electronic and not a spinning cable version and I can see the wires corroded and broken where it...
I'd say little rich. Look at the centre core area which should be a deep coffee colour. Yours is black. Ignore outer threads, they get oiled up....
I'm setting some on my 650bike so I'll compare and see if it's just me being dumb.
I'm trying to adjust the valve clearance on single cylinder 4T 125cc . Problems with starting and Rickover. I have set the timing to the...
Hi thanks for the replies, it's appreciated; I might swap the rubber seals over as well now you mention it. I'll check the speedo where you say...
Interesting answer, I spent the best part of the day swapping out rollers, contraspring and clutch torque pulleys to find the optimum set up for...
In the city nobody cares, anyone sat in their cars watching you whizz through traffic will be jealous! Get it running well and just enjoy the...
Hi I have just received a new clutch torque drive for gilera dna 50. I now realise that the old clutch pulleys are considerably bigger. The new...
Does it tickover nicely off the stand? If it revs well but then splutters when you rev it on the ground then it suggests that maybe it's...
hi i was having trouble on hills with my DNA 50 slowing to 10mph and revs dropping, so I replaced the stock contraspring with a white makuni...
Hi Just finished an engine rebuild on my lads DNA50. Waterpump had leaked and rusted so while the engine was apart I changed the main bearings,...
Does anyone know what the valve clearance is on KSR tw125? I think it might be a Suzuki 125 engine if that helps.
Sounds like a fuel issue. I would give the carb a clean first. Clean carb, check spark plug connections and try again. With the recent dry weather...
What's your budget
If the bike idles well then the idle jets fine. If it revs nicely and pulls nicely when the clutch engages then the clutch springs are fine. If...
Just seen your other post in the tuning section. Try stiffer clutch springs.
Slow pull away is often the clutch springs or rollers. If the clutch springs are weak the the shoes engage too early and it is like starting...
You havent described what problem you are having!? If its a slow pull away then it could be the rollers or the clutch springs. Work that out first...
